MYOG: tent free tent setup

Most tents these days seem to have a "fast and light" setup with just the footprint and fly. My Eureka Flashlight copycat tent (Alps Mountaineering Mystique 2) is not one of those. As something on the "inexpensive" end of the backpacking tent spectrum and a few years old, it weighs in pretty near 4.5 pounds and nearly half of that is the tent. It turns out, it really is not that difficult to do a "fast and light" setup for this tent. (Incidentally, the only slightly changed obnoxious orange ones they sell today still do not have a "fast and light" setup. Current minimum weight is 4 lbs 9 oz.)

Mildly lopsided, but that does not seem to be a problem. All set up sans tent.

Required material:
~25 feet of guy line, but the more the merrier

I used "yellow nylon draw cord 1/16th inch" from Outdoor Wilderness Fabrics. This is strong and has no stretch to it whatsoever. Also, quite obviously, it is nice and bright. It is suitable for use at guy line.

Construction:
The poles need attachment points on the fly. As it comes, there are four Velcro loops that attach around the poles, but these are not strong enough to use. Take four pieces of line long enough to comfortably tie around the poles. Sew these through the base of each Velcro tab. When tied, these lock down the Velcro around the poles.

Line pulled through the base of the Velcro tabs.
Tied to lock down the Velcro tabs around the pole.

On their own, the poles will spread wide. They need something to pull them in toward the middle. The solution is more cord. For the head side, take a length of cord 10-12 feet long. This is long enough to go across the entire width of the tent and vestibule area plus some room for knots. Tie two loops, each about 31 inches from the center. The loops should be just big enough to pass over the ends of the poles but not big enough to pass over the pole itself.  Tie a loop at either end with a slip knot to take a stake. (A rolling hitch is typical for the end of a guy line.)

For the foot side, take a length of cord 6-8 feet long. Tie loops in it about 21 inches from the center as before for the pole. Tie loops at either end as before for stakes.

Pole end stabilized by cord.
I just used an overhand knot to make the loop.
Cord to keep the poles placed and tensioned.
Head end too.

Loops for stakes are needed around the edges where the fly would have been connected to the tent. Take foot long lengths, thread them through the loop the buckle is attached to and tie it. I just used big loops, but more traditional guy line modes would be fine too. Presumably one could take a hammer or saw to the clips to remove them if one never wanted to use the fly with the tent again.

Just need a little guy line.

Set up:
Expand the poles and lock them into the Velcro attachments. Tuck the cord loops over the ends.

Start at the head end and place two stakes so the front is tight enough. Place the front pole as desired. Pushing it up toward the front will make the fly higher for more air flow while sliding it back a little can lock it down tight. Place the back pole. Without letting go on the tension holding up the tent, place the two stakes at the foot.

Place the stakes around the side so that they hold both the fly edge and the end of the pole cord.

Ready to keep off the rain.

Weights:
Fly and all guy lines: 1.55 lbs (705g)
Poles: 0.78 lbs (352g)
Stakes (8 of those provided with tent): 0.27 lbs (122g)
For a total of 2.6 lbs (1179g)

Tent left at home: 1.76 lbs (797g)
Note: the loops that I have added at either end of the fly are due to its tendency to sag onto the tent in everyday use. Those are not needed for this setup.

Thoughts:
It seems very forgiving of getting things placed a little lopsided. It is pretty solid standing and still quite solid with the doors open. It is a rather comfortable space on the inside, if a little short, and the vestibules give a lot of elbow room. One might even be comfortable using it as the two man space the tent was designed to be. Admittedly this is only the second time I have set it up this way. Testing up on a ridge in a minor storm was the first. Yes, it probably was foolish to head out without actually checking that it would work, but I had a clear vision and managed not to forget anything. There was enough wind to keep things ventilated, but not too bad, and it did not care. It rained a couple times (that I was awake for) and not one drop hit me.

Yes, I can keep the bugs off with my bug net hung from the pole.

Hope that is understandable to anyone with this or a similar tent and wishing it was lighter, but not wanting to spend loads of cash. Also, I hope people with other tents without a "fast and light" setup might find my procedure to develop this setup helpful.

Liked this? Interesting? Click the three bars at the top left for the menu to read more or subscribe!


Comments

popular posts:

Jennie Lakes: Belle Canyon and Rowell Meadow

California Coastal Trail - Arcata to Crescent City - hiking guide

Bluff Creek Historic Trail

Loleta Tunnel